Jump to content

All Activity

This stream auto-updates

  1. Past hour
  2. In the same vein as before, it would be helpful to read the data from the sensors and look for error codes using a program like ForScan in order to inspect the crank, cam, and (less likely) coolant temperature sensors to see if they are about to fail. The symptoms, however, suggest a fuelling problem, specifically either "flooding" or vapourization. I assume that after changing the fuel rail, all of the injectors were also changed? The decision to "throw parts and money at it until it happens to be fixed" seems like it may have been influenced by some factors, but I'm curious about which ones. Uh oh. A malfunctioning fuel pump that isn't producing enough pressure or letting fuel return to the tank (when warm) could be the next likely culprit. A couple of fuel system tests could be attempted: after it has sat for a few minutes, turn the key to the ignition but do not start the engine. Ideally, you will hear the pump start up, prime it, and then turn off. After that, turn the key in the ignition twice (without starting the engine) to hear if the noise comes back, and then start the engine. Is it easy to start or does it require a lot of cranking? If it does, you can induce flooding in an old car by pressing down on the accelerator while cranking it. Is it now easier to start? I believe you can even read real-time fuel pressure data with a diagnostic, and it will help you rule in or out sensors. I mentioned a test that could be helpful. When the car was pointed uphill, it would require a lot of cranking to start when it was warm, but when it was pointed downhill, it would start without any cranking. It was a strange thing. A new fuel pump return valve fixed the problem, which was actually a known issue with that vehicle.
  3. Perhaps the crank sensor is getting too hot and is experiencing high resistance or an open circuit. Check the resistance across the terminals (it should be less than 1,000 ohms/1k ohm) if you are competent enough to remove it yourself. After a few minutes in boiling water, you should recheck the resistance. It's possible that it might change, but probably not much. particularly because starting the engine becomes a breeze once you allow it to cool down.
  4. I really appreciate your feedback; it has been quite useful. Oh, I almost forgot to say that you can start the engine immediately after turning it off; the only catch is that it needs some time to cool down. I'm not sure if this helps clarify the issue. Best regards
  5. Today
  6. In short, "warm" starts aren't good for the car. It seems like you're experiencing a heat soak problem, which can have multiple causes. The Renault 5 turbos were known to have this issue, but the reason behind that specific fault won't apply to your vehicle because the carburettor was positioned above the turbo in that model. A carburettor isn't even an accessory on your vehicle. Have you ever wondered how the mechanics at your neighbourhood repair shop arrived at their wrong diagnosis? Looking at live data from multiple sensors - first under proper cold start conditions - as a baseline, then while running, and finally when attempting a warm start - will likely help get to the bottom of this. A diagnostics tool, like an Autel or similar, or Forscan could be useful for this purpose. While some parameter changes are to be expected, the ones that stand out will be your focus. I am just bringing this up as an example and not saying it's the cause, but there's a chance (and I mean "possibility") that a sensor is starting to fail and is reporting incorrect values when hot, which confuses the PCM into delivering the wrong amount of fuel. Is the vehicle code scanner running? The malfunction indicator lamp (MIL) doesn't necessarily have to be on for fault codes to be stored. First and foremost, we require data in this case. We can increase our chances of determining what's causing your starting problems by collecting as much data as possible from the vehicle.
  7. https://www.amazon.com/s?ascsubtag=v1-be0c33-416572-b2808c947e-b&k=Ford
  8. Hi there About three years passed before I got my 2010 Ford Fiesta 1.25 duratec back on the road. Turned it back on, and it runs like new after that. Nothing wrong with starting it cold, but even after a brief run and a few minutes of park up, it needs turning over and over again before it finally kicks in, sometimes more than once. Reiterating, it functions properly once started. The fuel bar was deemed malfunctioning by the local garage, but even after replacing it, nothing changed. Would greatly appreciate any advice or suggestions.
  9. Yesterday
  10. I usually have mine set to B, but I switch to D when I'm on autoroutes. Using Eco slightly lowers the performance, which makes it more refined around town, but that's just my opinion. Even though I use the air conditioner constantly (inside and out), regardless of the weather, I'm still pleased with the 65 mpg that the vehicle is indicating. This is despite the fact that I do a lot of short trips.
  11. As previously mentioned, it is dependent on your usage. A few months ago, we sold my wife's 2024 (2025 model year) Clio full hybrid, which was getting around 72 mpg with a "best" of 75.1. You can't expect the same mpg if your use is primarily urban (we live in a rural area anyway), but we discovered that 'B'mode worked best for us since the car spent a lot of time in 'EV' due to our hilly Derbyshire home and the fact that the downhill stretches helped recharge the battery considerably. "Horses for courses," I suppose, but all I can say is try different configurations until you discover what suits your needs the best.
  12. Your daily commute details, including the distance travelled, average speed, road types, and whether you're in a city, a town, or a rural area, might be useful. How is the economy doing on average for you right now?
  13. Even though I've had this car for a while, I'm still learning how to drive it most efficiently. The guidance of any kind would be highly valued.
  14. Here you can find a wealth of information, including repair issues and tips. This is an excellent site for many things RR, so feel free to share your own if you have any. It's a comfortable ride, so enjoy!
  15. Rest assured, you will savour it and experience countless miles filled with joy 😃.
  16. I trust you will thoroughly relish your new vehicle.
  17. I'm looking forward to receiving my first Range Rover, a 2018 Evoque, and I can't wait to drive it because it looks beautiful and is so comfortable.
  18. There was just one hiccup when I made the change. It is impossible for a TPMS to display tyre pressures. After many days of driving, it still hadn't worked. I had the clock set to "manual" adjustment instead of auto-GPS update, and that turned out to be the cause. I was taken aback by the connection at first, but then I remembered that each tyre pressure check is time- and date-stamped.
  19. Nothing beats Deka Gold "647" when it comes to marketing
  20. A ten-millimeter wrench and a ten-minute oil change without memory lapse
  21. https://www.amazon.co.uk/s/?search-alias=aps&field-keywords=2021+Mazda+CX-30+battery
  22. I swapped out mine and never lost a setting, even when the battery was unplugged for ten minutes.
  1. Load more activity
×
×
  • Create New...